**** Connected scanner and retrieved the following trouble code(s): P0101 – Mass Air Flow Sensor/Circuit 1 **** Advised customer after visibly inspecting mass air flow sensor, technician found rubber boot from throttle body to air cleaner is torn, causing un- metered air into throttle body. **** Recommend replacing intake boot then clearing check engine light.
2*** REMOVE AND REPLACE AIR INTAKE BOOT
Raymond D. gave our service a 5 star review on 9/29/2022
37 POINT INSPECTION REPLACE ENGINE OIL REPLACE ENGINE OIL FILTER SET TIRE PRESSURE
2*** ROTATE TIRES
**** Replaced both front wiper blades.
Removed all four tires and inspected brake pad condition. Inspected brake calipers. Inspected brake hoses. Inspected master cylinder and all other brake system components. **** Advised customer found that the brakes are in good condition at this time. Found that the passenger rear calipers lower slide pin was starting to seize up, freed up the slide pin and lubricated.
*** REMOVE & REPLACE ENGINE AIR FILTER.
*** REMOVE AND REPLACE EXTERIOR LIGHT BULB. Includes: Clean socket where necessary.
Sherrli Z. gave our service a 5 star review on 8/24/2022
Brakes: Front at 8/32"; Rear at 14/32" Tires: 7/32" LF; 7/32" RF; 7/32" LR; 7/32" RR AI204282100 Expires: 05/2023 **** Advised customer rear brake pads are worn low on material at 3/32" and rear rotors are to rusted to machine. Recommend replacing rear brake pads and rear rotors soon.
IM23256513 Expires: 05/2023
3*** ROTATE TIRES
**** Advised customer technician did feel a pulsation while braking. Front brake pads are in good condition at 8/32", front rotors are starting to warp. Recommend machining front rotors and cleaning front brake pads.
*** MACHINE BRAKE ROTOR OR DRUM. Includes: Remove and re install from vehicle, clean/lube pad and brackets as necessary. Adjust where applicable.
Removed all four tires and inspected brake pad condition. Inspected brake calipers. Inspected brake hoses. Inspected master cylinder and all other brake system components. **** Advised customer brakes are in good condition at 7/32"
**** Connected scanner and retrieved the following trouble code(s): No codes in ABS at this time. **** Advised customer while driving left front wheel speed sensor would periodically drop, indicating a bad ABS ring in bearing. Recommend replacing left front hub bearing.
*** Was not able to duplicate this condition at this time. No codes in control module at this time. Recommend returning and leaving vehicle for day to drive multiple times if problem persists.
Jeff / Kathy L. gave our service a 5 star review on 1/29/2022